Laundry_Mike
12-02-2002, 09:15 PM
I have a Heubsch 35# washer that about once every 8 loads or so, it will blow a fuse when going into the extract cycle. There is no problem with the drain, I've switched the Sinpack with another machine, continuity tested the extract relay, and it seems to be OK. Any suggestions? /ubbthreads/images/graemlins/confused.gif
RWSmith
12-04-2002, 12:09 PM
Check to make sure the washer is dumping the water in 30 to 45 seconds. If it is not clean the drain or drain line out.
LEEHUSTON
01-28-2003, 01:49 AM
I had the same problem on a 50 SQ and it turned out to be a bad connection in the wiring harness plug that connects the motor to the spin relay. You may want to pull this plug apart and make sure there is not a burned pin. The machine was still under warranty and they gave me a new harness. Seems ok now, but I think SQ has been having some trouble with these connections.