pressuore boost pump

[James2011]

I think the problem in my MAT is not enough water coming in...in order words, water pressure in city main line at entrance point of store is not high enough to provide water...
so, I am looking for any way to boost the pressure...
I was told one time, there is some kind of PUMP which can be installed after main water shut-off valve and it can boost water pressure....
Have you heard about this?

Thanks,

[eighty20]

One of my brand new dexters is not giving any water. I am getting an F-2. Could this be due to lack of water pressure.

anyone seen this before?

[hecdav1]

as per dexter codes F2 is washer not filling within 7 minutes checkn water valves /check rear water conections screens
as per dexter this will not interfere with function of washer will flash 3 times every so often but cycle continuos and fault clear at end of cycle .FYI

[merlin3]

[ QUOTE ]
One of my brand new dexters is not giving any water. I am getting an F-2. Could this be due to lack of water pressure.

anyone seen this before?

[/ QUOTE ]

hecdav answered below and I'm sure it was a typo but F2 is failure to fill within 2 minutes. Yes, check that your supply valves are all the way open and the screens are clean. I had trouble in my store with people going behind the machines and turning my water valves off.

[laundrym]

Booster pumps are very common within Laundromats. The most common aplication is made by Grundfos. This is a maintanence free pump which is made to run continuousely around the clock. It will take care of your pressure issues and then some. I usually get mine at laundry motors in los angeles.